My 93 yamaha virago 535 sat for about one and a half years (friend owned it for that time) and has under 3000 miles on it. im fixing it up and have gotten it running again. when i first start it and ride it around it is ok and hte clutch works fine, but... Read More

Ive purchased a new belt for my Yamaha Apex snowmobile and i cannot install it. Ive tried sliding the clutch lever back until it reaches the end, (turning it back), and putting it on the top and bottom first but it will not go on. Is there a trick to... Read More

Does anyone know a website to look at and learn how to install a clutch for a four wheeler. Its a 350 Yamaha Warrior. Thanks Posted by Kendra M  Read More Ø

I have an original Ford Mustang 3 speed clutch kit; I don’t need it, so I want to sell it, how much should I charge? Posted by nubby  Read More Ø

I have a car that the clutch went out on and I droped it off at this car repair place over 5 weeks ago. Every time I call to see what is going on they say Oh they didnt call you it should be done tomorrow. On monday of this week my Boyfirend called over... Read More

I’m looking for motorcycle that is not too powerful that’s easy to control. The last time i tried to ride one, I barely let go of the clutch and it kicked back, causing me pull back on the accelerator, pop a wheelie, and fall off. Posted by... Read More

My clutch recently burnt out on me on my 1998 yamaha blaster yfs200. I have seen a few forum’s on changing clutches, but I have never fully understood them! Money is short at hand, so taking it to the dealer is out of the question. Please offer... Read More

I am replacing the clutch of my 89 ford ranger, 4 cylinder standard transmission truck. I got partially through but got stuck on the removal of the drive shaft. I need to get the drive shaft out but cannot find detailed instructions on how to do so. Anyone... Read More

I am not sure if you are supposed to hold the clutch in while downshifting and braking or to brake and downshift through each gear simultaneously while normally releasing the clutch. Pretty much how to stop a motorcycle at higher speeds for a red light. Posted... Read More

I have a Ford Focus SE, and am being quoted approximately $1000 total parts/labor to replace it at the Ford dealership. Is that about right, or am I being overcharged? Posted by Mike  Read More Ø